Driver backrest yamaha road star




















Detachable storage pouch measures 9"W x 6"H and is protected by the driver backrest built in rain flap. The Ultimate large sissy bar pad is 12" wide and 8" high. We also manufacture large sissy bar pads that will fit other aftermarket sissy bars. Your Cart. Road Star Our Midrider seat will sit you at the same height and the same distance to the handlebars as your stock seat. Ultimate Removable Driver Backrest All Ultimate Road Star passenger seats have the driver backrest hardware built into them, so you can add the backrest at any time.

Pad measures 7" high by 10" wide by 1. Built using the same memory foam as our seats. This will be the lateral locking point for the soon to be formed flat stock used for the drivers backrest pad. Reassemble the passenger seat bracket on to the seat pad and install. I used a stud in place of the bolt used to hold that assembly on to the front section of the rear fender. Now for the fabrication of the flat stock. I rough cut the length to about 1 foot for ease of forming since it comes in a 3 foot length.

I inserted one end into the vice about 3 inches and made sure it was square to the vice jaws, this will prevent the bar being twisted and hence the backrest pad. The slot is the width of the stud to make the fit snug,. The stud I believe is a 6MM shaft. Once this is tweaked to your liking I then installed the drivers seat with the J bar installed tight with a flanged nut on the stud..

One pain is the limited wrench space to torque the nut on the stud. It may look tight but it can be done with a wrench or inch socket. You may have to move side to side on either side of the J bar to tighten the nut but it can be done.

Now onto the pad mounting. Polyurethane bumpers are strategically located and riveted to the baseplate to prevent it from touching the frame and fender and to minimize vibration.

Mustang's unique internal support wings are added to the baseplate to provide maximum driver and passenger comfort. These wings support the entire width of the molded foam. This feature is found on most Mustang touring seats. Bumpers will not crack with age and are ozone protected. Solos with built-in driver backrests have the receiver welded and reinforced to the baseplate for strength. Foam surrounds the hardware to provide maximum comfort. Foam All foam is compounded and molded at our New England facility.

For a seat to be comfortable, "it's what's inside that counts". The most important component of comfort is the seat foam--both the quality of the foam itself and its design. Each Mustang foam is formulated and cast to be soft enough for comfort and resilient enough to stand up to those "thousand- mile" days. Mustang has over 25 years of experience in compounding the right chemical mix to create the best controlled density polyurethane foam for all-day comfort.

The foam has a density of approximately four pounds per cubic foot, depending on the size and thickness of the seat. The foam must then be molded to the correct shape to support your body at the best angle.

Mustang's high quality foam usually feels firmer than stock but is less firm than other aftermarket seats. It will compress enough to mold itself to your body shape within about 15 minutes of riding time--every time you ride. You do not need a "break-in" period to be comfortable. Your th ride will be equal to your 10,th mile.

Mustang seats are known for retaining their shape and support after years of use. Reckless Motorcycles TKY. Ships in weeks. Product Descriptions This Mustang Two Piece Seat with Driver Backrest, Studs is made specifically for Yamaha Road Star current Sold as a complete three-piece set including solo, removable driver backrest and matching passenger seat.



0コメント

  • 1000 / 1000